Introduction

Program simulation allows you to test a program and modify its parameters. This ensures the download of a fully functioning and optimized program to your LOGO!.

Simulation mode

Click on the Simulation icon in the programming toolbar to start the simulation. This changes the program to simulation mode.

→ Simulation

The active icon is highlighted in simulation mode. If the IP address of the circuit program is configured, you can click the icon to simulate the circuit program in the network. You can watch VM values via the "Data Table" window. To exit the simulation mode, click the Simulation icon or any other icon of the programming toolbar. If you click another icon, you exit the simulation mode and open the tool mode of the icon that you clicked, for example selecting or inserting blocks.

At the start of the simulation mode, LOGO!Soft Comfort verifies the circuit program and displays the results in the Info Window.